Trial & Installation Process

Trial process

Madico and YS product specialists will carry out on-site technical evaluation.

This will involve initial evaluation of labelstock/s using a manual (hand) applicator to determine material requirements.

Usually a standard Heatproof material will comply with all demands but should a material modification be required further laboratory work will be completed to create a bespoke material. Once printing, application, scanning and process trials have been completed the site can be surveyed to determine applicator sighting, design and data communications.


Installation & operator training

Once an applicator is installed engineers will remain on site to ensure local operators are fully conversant with all operating and service requirements. This training usually takes 5-7 days.















Manual application to a hot aluminum coil


Applicator